Easily enable visualization
at greatly reduced introduction cost
Check equipment screens remotely
using an office PC or smartphone web browser
Supporting various communications protocols for linking higher-level information systems with lower-level control systems, the WH series acts as a network gateway.
Connection with higher-level systems
The WH series supports OPC UA, MQTT, SQL, etc., and can connect to higher-level control systems such as MES, SCADA, and various cloud platforms. By installing the WH series you can monitor equipment readings by providing a gateway through which existing equipment is linked to the host system. Thus acquired, equipment data can be included in analysis.
Programming-free connection to PLCs of different companies
Able to handle communications protocols used by various PLCs. Naturally, the gateway can be implemented when you install new equipment, but it can also be used to connect existing equipment.
By simply replacing the display on newly installed equipment and, even, legacy equipment you can remotely visualize the status of field devices.
Simultaneous connection to different communication protocols
Via Ethernet, WHA1 (advanced model) can connect using a total of 8 different communication protocols.
WHS1 (standard model) enables connection using as many as 4 different protocols.
Equipped with 3 Ethernet ports* and a capacitive type, the large, high end model enables gesture control.
* AWHA1C050 is equipped with two Ethernet ports.
|
|
Standard model with mid-sized, wide resistive film type for users with focused needs.
|
Standard model
Tolerance (except T): ±1 mm ±0.039 in
T tolerance: ±0.5 mm ±0.020 in
Advanced model
Advanced model
Tolerance (except T): ±1 mm ±0.039 in
T tolerance: ±0.5 mm ±0.020 in
TITLE | DOCUMENT TYPE | SIZE |
WH | Catalog | 3718 KB |
---|---|---|
WHA1 Series | Manual | 1938 KB |
WHS1 Series | Manual | 1807 KB |
xAscender Studio (Basic) | Manual | 5723 KB |
xAscender Studio (Communication) | Manual | 7914 KB |