All you need to do is to make a ø4 mm ø0.157 in hole where you would like to stop or check the object (ø6 mm ø0.236 in hole for reflective type).
Furthermore, the center of the sensing axis is the same as the center of the mounting hole, which makes it much easier to set the sensing position.

The EX-30 series achieves long distance sensing.
[thru-beam type: 500 mm 19.685 in (EX-33(-PN): 800 mm 31.496 in), reflective type: 50 mm 1.969 in.]

The EX-30 series can be screwmounted (M4 for thrubeam type, M6 for reflective type) in the same way as standard fiber sensors. This means that they can be inserted into production lines in exactly the same way as conventional high-priced fiber sensors.

Conventional photoelectric sensors required four (for thru-beam type) or two (for reflective type) mounting holes and screws to be used. However, the EX-30 series is installed with a single screw, thus cutting down on installation work by half.

Unlike conventional fibers, bending radius is not a problem, so that the sensor can be securely installed alongside conveyors.

The EX-30 series has high bending strength, so that the protective tube used to protect conventional fiber from breakage is not needed. This also adds up to excellent cost performance.

The sensors features an IP67 rating to allow their use in process lines where water is used or splashed.

Note: If water splashes on the sensor during sensing operation,
it may sense water as an object.

A bright 2-color indicator is incorporated in all types.

The sensor incorporates a sensitivity adjuster. It is convenient when you need fine adjustment.