5 A at 125 VAC, 3 A at 250 VAC (general use)
3 A at 30 VDC (resistive)
Note: Certification has been obtained for the Switch.For detailed information on individual products that have received certification, consult your supplier.

Minimum applicable load: 1 mA at 5 VDC Rated values are obtained from tests conducted under the following conditions.
  1. Load: Resistive load
  2. Mounting conditions: No vibration and no shock
  3. Temperature: 20 ±2°C
  4. Operating frequency: 20 operations/min

* The voltage display surface is the same color as the illumination color.The opposite surface is light gray.(For pure white, the entire surface is light gray.)

Note: 1. The panel is 0.6 mm thick.

          2. The panel is made of the materials listed in the following table.

Note: • Make sure the thickness of the mounting panel is between 0.5 and 3.2mm. If, however, a Switch Guard or Dust Cover is used, the thickness of the mounting panel must be between 0.5 and 2 mm.
         • If the panel is to be finished with coating, etc., make sure that the panel meets the specified dimensions after coating.
          • Figures in parentheses are for Screw-less Clamp Connectors.

Note: • Ensure that the variation in the distance between the centers of neighboring mounting holes is less than ±0.1mm.
         • Make sure the thickness of the mounting panel is between 0.5 and 3.2mm. If, however, a Switch Guard or Dust Cover is used, the thickness of the mounting panel must be between 0.5 and 2 mm.
         • If the panel is to be finished with coating, etc., make sure that the panel meets the specified dimensions after coating.

Note: This example is for when X is 4.5 mm.If X is not required, the Switches can be mounted with a minimum vertical installation pitch of 24 mm min.

Note: This example is for when X is 4.5mm. If X is not required, the Switches can be mounted with a minimum vertical installation pitch of 24 mm min. If PCB terminals are used, provide X must be 24 mm or larger.