The mounting pitch for sensor heads is 25.4 mm 1.000 in, the same industry standard as the CX-400 series Ver.2 general purpose photoelectric sensors. Hence, existing mounting brackets can be used even when replacing general purpose sensors with laser sensors. |
[Long sensing range spot reflective type] [Long sensing range line reflective type]
A spot-size adjuster is built into the back of the sensor head allowing the user to adjust the sensor easily while viewing the spot. The adjuster is adjustable with a screwdriver to avoid accidents during maintenance or any other time the sensors are handled. |
Visible light spot using the Class 1 type. This makes beam axis alignment much easier. |
It is possible to make a minor adjustment for the bracket by 4 degrees up, down, right or left, even after setting up the sensor. The bracket can be mounted in both longitudinal and lateral directions.
|
Only two switches, the large MODE key and the large jog switch, are required for operation.
The quick-connection cables enable reductions in wiring.
|
|
* | CC-Link and CC-Link IE Field are a registered trademark of Mitsubishi Electric Corporation. DeviceNet is a registered trademark of ODVA (Open DeviceNet Vender Association, Inc.). EtherCAT is a registered trademark of Beckhoff Automation GmbH. |
---|---|
* | Refer to SC-GU3 series. |
This function seeks changes in the light emitting amount resulting from changes in the environment over long periods (such as dust levels), so that the incident light intensity can be checked at desired intervals and the threshold values can be reset automatically. This helps to reduce the man-hours for maintenance. |
When sensing at close range or when the target objects are transparent or minute, adjust the sensor receiving sensitivity to one of 3 levels (U-LG mode: 4 levels) for the optimal setting. In addition, changing the receiving sensitivity will not effect the response time.
[Hysteresis mode] |
[Window comparator mode] |
[2 independent output modes] |
[Differential sensing mode] Only rapid changes in light received are detected, which enable the edge of glass, etc. to be detected accurately. Optimal for positioning. |
|
If you do not want to place a laser spot in the visual range of the image processor, you can stop the laser radiation using the emission halt signal from the external input. |
The LS-401-C2 cable-type amplifier is equipped with an external input wire (5-core). It is ideal to use the laser sensor at places where external teaching or laser light emission halting is to be carried out, or at places where the laser sensor is to be used separately. |
The automatic interference prevention function prevents against interference among up to 4 sensors. |
The amplifier setting is shown in an 8-digit code. This is handy for remote indications and follow-ups. |
Sensor head
Sensor head
Sensor head
Sensor head
Amplifier
Amplifier
Main cable (Optional)
Length L
Sub cable (Optional)
Length L
End plate (Optional)
|
Reflector [Accessory for LS-H92(F)]
|
Reflector (Accessory for LS-H91□)
|
Reflector (Optional)
|
Reflective tape (Optional)
Amplifier mounting bracket (Optional)
|
Sensor head mounting bracket (Optional)
|
Sensor head mounting bracket (Optional)
|
Sensor head mounting bracket (Optional)
|
Sensor head mounting bracket (Optional)
|
Sensor mounting bracket for beam axis alignment (Optional)
|
|
|